§ 30-112. Driveway location, design and construction requirements.

(a)

General requirements. The location, design and construction of driveways shall be in accordance with the following:

(1)

General design. Private driveways shall be of such width and so located that all of such driveways and their appurtenances are within the limits of the frontage abutting the street of the property served. Driveways shall not provide direct ingress or egress to or from any street intersection area and shall not encroach upon or occupy areas of the street right-of-way required for effective traffic control or for street signs or signals. A driveway shall be so located and constructed that vehicles approaching or using it shall have adequate sight distance along the street. Driveway approaches shall be at least ten feet apart except by special permission from the village board, and driveways shall in all cases be placed wherever possible as not to interfere with utilities in place.

(2)

Number. The number of driveways to serve an individual property fronting on a street shall be one, except where deemed necessary and feasible by the superintendent of streets for reasonable and adequate service to the property, considering the safety, convenience and utility of the street.

(3)

Island area. The island area in the street right-of-way between successive driveways or adjoining a driveway and between the highway shoulder and right-of-way shall constitute a restricted area and may be filled in and graded only as provided in subsection (a)(7) of this section.

(4)

Drainage. The surface of the driveway connecting with rural type street cross sections shall slope downward and away from the highway shoulder a sufficient distance to preclude ordinary surface water drainage flowing onto the street roadbed.

(5)

Culverts. Driveways shall not obstruct or impair drainage in street ditches or roadside areas. Driveway culverts, where required, shall be adequate for surface water drainage along the street and shall not be less than the equivalent of a 12-inch diameter pipe. The distance between culverts under successive driveways shall not be less than ten feet except as such restricted area is permitted to be filled in pursuant to the provisions of subsection (7) of this section. Culverts shall be paid for by the property owner.

(6)

Reconstruction of sidewalks and curb and gutter. When the construction of a driveway requires the removal of a curb or gutter the new connections shall be of equivalent acceptable material and curb returns shall be provided or restored in a neat, workmanlike manner. The driveway surface shall be connected with the highway pavement and the sidewalk, if any, in a neat, workmanlike manner. The driveway construction shall include the replacement of such sidewalk areas which are inadequate or which are or may be damaged by means of vehicle travel across the sidewalk.

(7)

Restricted areas. The restricted area between successive driveways may be filled in and graded only when the following requirements are complied with:

a.

The filling or draining shall be to grades approved by the village and, except where highway drainage is by means of curb and gutter, water drainage of the area shall be directed away from the street roadbed in a suitable manner.

b.

Culvert extensions under the restricted area shall be of the same size and of equivalent acceptable material as the culvert under the driveway. Intermediate manholes adequate for cleanout purposes may be required where the total culvert length is excessive.

c.

Where no street side ditch separates the restricted area from the street roadbed, permanent provision may be required to separate the area from the street roadbed to prevent its use for driveway or parking purposes by construction of a border, curb, rail or posts as may be required by the village boards.

(8)

Relocation of utilities. Any costs of relocating public utilities shall be the responsibility of the property owner with approval of the village board or authorized committee thereof necessary before any utility may be relocated and the driveway installed.

(9)

Construction across sidewalks. All driveway entrances and approaches which are constructed across sidewalks shall be of concrete constructed in accordance with the requirements for sidewalk construction in section 30-56 insofar as such requirements are applicable, including thickness requirements.

(10)

Variances. Any of the requirements referenced in the previous subsections may be varied by the village board in such instances where the peculiar nature of the property or the design of the street may make the rigid adherence to the requirements referenced in the previous subsections impossible or impractical.

(b)

Special requirements for commercial and industrial driveways. The following regulations are applicable to driveways serving commercial or industrial establishments:

(1)

Width of drive. No part of a private driveway located within the dedicated area of a public street shall, except as hereinafter provided, have a width greater than 30 feet measured at right angles to the centerline of said driveway, except as increased by permissible radii. In instances where the nature of the commercial or industrial activity or the physical characteristics of the land would require a driveway of greater width than herein specified, the village board in its discretion may permit a driveway of additional width.

(2)

Angular placement of driveway. The angle between the centerline of the driveway and the curbline shall not be less than 45 degrees.

(3)

Island areas. Where the public sidewalk is adjacent to the curb, an island of a minimum length of six feet measured along the curbline shall be placed between each entrance to a village street. The curb shall be left intact for the length of this island. Where the public sidewalk is remote from the curb, an island of a minimum length of ten feet measured along the right-of-way line shall be maintained along each entrance to the village street. All flares shall be tangent to the curbline. A curb length of not less than three feet shall be left undisturbed adjacent to each property line to serve as an island area in the event an adjoining property owner applies for a driveway permit to serve his property.

(c)

Special requirements for residential driveways. The following regulations are applicable to driveways serving residential property:

(1)

Width of driveways. Openings for vehicular ingress and egress shall be at least ten feet wide at the property line for residential properties, but shall not exceed 24 feet at the property line and 30 feet at the curb opening.

(2)

Angular placement. The centerline of the drive may be parallel to the property line of the lot where access is required or at right angles to the curbline.

(d)

Appeal from permit refusal. Any person feeling himself aggrieved by the refusal of the street superintendent to issue a permit for a private driveway may appeal such refusal to the village board within 20 days after such refusal to issue such permit is made.

(e)

Prohibited driveways. The following provisions apply to driveways prohibited within the village:

(1)

No person shall place, construct, locate in, or cause to be placed, constructed or located in, any obstruction or structure within the limits of any public road, highway or street in the village except as permitted by this section. As used herein the term "structure" includes private driveways, a portion of which extends into any public road, highway or street, and which is in nonconformance with this article.

(2)

No driveway shall be closer than ten feet to the extended street line at an intersection. At street intersections a driveway shall not provide direct ingress or egress to or from the street intersection area and shall not occupy areas of the roadway deemed necessary by the village for effective traffic control or for highway signs or signals.

(3)

The grade of that portion of any private driveway or pedestrian path located within the limits of any public road, highway or street shall be such as shall meet the grade of the existing public roadway at its edge and not cause an obstruction to the maintenance or clearing of such public roadway.

(4)

No driveway apron shall extend out into the street further than the facing of the curb and under no circumstances shall such driveway apron extend into any gutter area. All driveway entrances and approaches shall be constructed as not to interfere with the drainage of streets, side ditches or roadside areas, or with any existing structure on the right-of-way.

(5)

No portion of any curb, parapet or retaining wall, rising above the grade of the driveway, erected by the owner of the premises involved shall extend beyond the culvert spanning the watercourse located in such public way.

(Code 1990, § 6-3-2)